1. Place the heating button at "O". After natural cooling, cover the roller surface with wet cloth without closing the rolling button. After the adhesive is softened, start cleaning the machine
2. Wipe each roller gently with a soft cloth fully soaked until it is completely clean. The wiping direction must be from the end of the shaft to the middle, so that the adhesive can be separated from the roller as far as possible, and avoid falling into the bearing, causing failure.
3 After the roller is wiped clean, please turn off the power, unplug the plug, take out the chassis, scrub it with hot soapy water or detergent, rinse it with water, and add the chassis.
4. Fully wipe the rest of the machine with a damp hot soft cloth until it is completely clean.
5. The placement site shall be free from direct sunlight, dust and good ventilation.
















