Freezers are mostly used in shops, shopping malls, nightclubs, karaoke and other places. However, the service life will be affected if it is not properly maintained. The following is the maintenance method of the freezer.
1. The display cabinet should be placed on a flat ground, although the use environment is good. Do not lie on your back. The indoor environment where the refrigerator is placed should be well ventilated and dry, with the top 50 cm above the ceiling, the left and right sides 20 cm above other objects, and the front 20 cm above other objects.
2. The newly purchased or handled furniture cabinet should be left standing for 2 to 6 hours before starting. Before use, the cabinet cannot be started immediately after it is powered on for operation and shutdown for 2 to 6 hours, and it needs to wait for more than 5 minutes to avoid burning the compressor. The gear position of the temperature controller of the general refrigerator shall be adjusted appropriately according to the season, ambient temperature and service conditions.
3. In summer, it is appropriate to set the thermostat at 5 "or 6"; In spring and autumn, it is appropriate to place the temperature controller at 3 "or 4". When the refrigerator is used, the number of times to open the door should be reduced as far as possible to shorten the time for storing and storing food. Hot food should be cooled to room temperature before being put into the freezer. For indirect air-cooled freezers, food shall not be kept too close to the air outlet.
4. For the direct cooling freezer, when the frost thickness reaches 5mm, manual defrosting is required. Routine maintenance: clean the compressor and condenser regularly. Regularly clean the refrigerator at least once every two months. When cleaning the refrigerator, first cut off the power, gently scrub it with neutral detergent and water, and then wipe it with clean water.
5. Do not use washing powder, detergent, talcum powder, alkaline detergent, Tianna water, boiled water, oil, brush, etc. to clean the furniture cabinet. When the refrigerator is not used for a long time, unplug the power plug, wipe the refrigerator clean, and close the cabinet door after the cabinet is fully dry.
Electric refrigerators that are out of service in cold days should be powered on 1-2 times at least a month to keep the refrigerator running for 10 minutes. At the same time, it must be thoroughly maintained during the initial shutdown.
The condenser and compressor of the refrigerator are mostly exposed to the outside, which are easily stained with dust, spider webs, etc., and should be brushed off with a soft brush. Do not flush the condenser and compressor with water to avoid reducing the insulation performance of electrical appliances. When cleaning the inner wall, all articles and parts shall be taken out, and a thorough sweeping shall be carried out. At the same time, the door seal shall be wiped clean, and an appropriate amount of talcum powder shall be applied to avoid adhesion of the seal.
If there is still odor in the interior after cleaning, you can carefully scrub the interior wall of the storage room with 3% sodium bicarbonate to quickly remove the odor. In addition, do not forcibly cut off the power supply of the refrigerator. If the power supply is forcibly cut off, the power supply is immediately switched on when the refrigerant has a fairly high pressure. The high pressure causes excessive load on the motor. At this time, the starting current is about 20-30 times of the normal value, which is easy to burn the motor. Therefore, when the electric refrigerator is stopped, the power plug can only be unplugged after the temperature in the refrigerator drops to a certain value and the thermostat automatically cuts off the power.
















